ENG4
Attaching legs
The turntable comes with its own legs so it can stand alone. Alternatively, the legs can be removed,
and it can sit on a table or shelf. To attach the legs to the turntable, screw each individual leg to
the metal plates on the bottom of the unit.
Initial setup
MAINS CONNECTION
Ensure that the mains voltage of your home corresponds to the operating voltage of the unit.
Your unit is ready to be connected to 5V DC adaptor.
AMPLIFIER CONNECTION (if required)
Whilst you can listen to your new turntable using the built-in speakers you may wish to
connect it to your existing Hi-Fi system. Connect the audio connectors to the Line input on
your mixer or amplifier using an RCA cable (not supplied).
Red plug into R channel.
White plug into L channel.
Playing a record
• Place the record on the turntable. If required, do not forget to place the adaptor on the record spindle.
• Choose the desired playing speed using the speed selector between 33 1/3, 45 and 78 RPM.
• Remove the protective cap from the stylus.
• Turn on the Rotary Power Switch, note that this also controls volume.
• Release the tone arm lock.
• Carefully raise the tone arm.
• Place the stylus vertically over the first track of the record; the turntable will start turning automatically.
• Lower the tone arm slowly on to the record to play.
• When a record comes to an end and the tone arm is returned to the tone arm rest,
the turntable will stop automatically.
• Lift the tone arm and put it on the rest when finished.
• Place the protective cap on the stylus and close the tone arm lock.
Note
: If your record stops before the last track finishes, set the auto-stop switch to OFF.
Your record will now play to the end, but you will have to stop the turntable rotation manually.
Auto Stop
• When a record finish playing, it can be controlled by the auto-stop ON/OFF switch.
• Lift the tone arm and put it on the rest when finished.
• Place the protective cap on the stylus and close the tone arm lock.