English - 2
AC Operation
Before operation please ensure that the VOLTAGE on the set corresponds to
the VOLTAGE of your local area. Unravel the AC Line Cord; insert one end
into the AC jack on the set and the other end into a standard AC outlet.
Remarks:
1.In case of malfunction due to electrostatic discharge (ESD), reset the unit by
reconnecting the AC cord again to resume to normal operation.
2. When not in use – Unplug the AC power cord completely from the AC socket.
BATTERY OPERATION
Disconnect the AC Cord Set completely. Open the BATTERY COMPARTMENT
DOOR and insert UM-2/ “C” size x 8 batteries (not supplied) making sure that
the indicated battery polarity is observed.
RADIO OPERATION
1.
Slide the FUNCTION switch to the “RADIO” position.
2.
Slide the BAND switch to the desired waveband.
3.
Turn the TUNING KNOB to your desired radio station.
4.
Adjust the sound level by rotating the VOLUME CONTROL KNOB.
5.
To turn off the radio, simply slide the FUNCTION SWITCH to “POWER
OFF” position.
Note: Radio frequency is shown on the TUNING KNOB.
FM STEREO INDICATOR
When tune to a FM stereo broadcast the “FM ST.” LED indicator will light up.
In weak signal areas the FM Stereo signal may not be strong enough and can
cause excessive background noise. In this case, slide the BAND SWITCH to
“FM” position.
ANTENNA
For best reception, fully extend the FM Antenna to receive FM station.
BASS BOOST
To increase bass at all volume levels, slide the BASS BOOST BUTTON to “ON”
position to boost the low frequency tone for an emphasized bass sound. To
release the super bass, simply slide the switch to “OFF” position.
