GB-2
Getting Started
Before using your Radio for DAB or FM, fully extend the TELESCOPIC ANTENNA and position
for the best reception.
Before connecting the power, check that the mains voltage on the rating plate of the AC adaptor
is same as the voltage in your area.
Plug the DC cord from the AC adaptor into the DC jack on the side of the unit.
Plug the AC adaptor into the wall socket and switch the mains power on.
Battery Operation
1. Remove the Battery Compartment Cover by gently pushing the clips downward and outwards.
2. Install 4 x 'AA' size batteries (UM-3 or equivalent) and take care that the correct polarities are
observed.
3. Replace the battery compartment cover.
NOTE:
The DC line cord must be removed for battery operation.
To avoid damage which may result from leaking batteries, remove the batteries when they
become exhausted or when the unit is not to be used for a long period of time.
Power Control
Press the button on the front panel to turn the radio on. The display will light and the radio will
switch on.
Press the button on the front panel again to turn the radio off.
When your radio is switched on for the first time the scanning will be processed automatically.
The radio scans all usable stations (full scan) and stores them alphanumerically. The initial scan
will take a few minutes. After the scan, the clock will be set and the radio will display the name of
the first station in the sequence. Press the TUN+ or TUN- button repeatedly to browse through
the station list. When you find a station you want to play, press the SEL button.
Note: If not any signals received in TWO hours during playback, the unit will be switched off. If the
unit is powered off automatically, it is necessary to press the STANDBY button on the unit again.
Selecting a Source
You can choose to DAB radio or FM radio. Press the BAND button repeatedly to scroll through
the available sources.
Adjusting the Volume
Press VOL+ or VOL- button to increase or decrease the volume level.
DAB Scanning
You can re-scan the band at any time if you move to a different area or just to refresh the stored
list of available stations.
Press the BAND button to select the DAB mode.
Press the MENU button to select FULL SCAN
DAB Display modes
The bottom line of the display can be switched to show different items of information that maybe
transmitted with a DAB station.
Press the INFO button repeatedly to change the information display while play a DAB radio
station.
The full range of display options are shown below. Some stations may not broadcast all of these
options.