the “TIME/PRESET” to stop blink and start setting.
The time can only be set when the radio is turned off. Press the “ON / OFF / NAP”
button (2) to turn radio on or off.
When the clock display is blinking, you cannot power on radio by the “ON / OFF /
NAP” button (2).
1.
Press and hold down “TIME / PRESET” button (6) for approximately 3 seconds
until the display flashes.
2.
Press “HOUR / TUNING –“ button (5) repeatedly to change the hour setting.
3.
Press “MIN / “ button (9) repeatedly to change the minute setting.
4.
Press “TIME / PRESET” button (6) to confirm at the time and the display will stop
flashing.
SETTING THE ALARM TIME
This clock radio has dual alarms that can be set and used independently. The
procedure to set both alarms are the same. Both alarms can either sound the buzzer
or wake up to radio.
Note: The alarm time can only be set when the radio is turned off. Press the “ON /
OFF / NAP” button (2) to turn radio on or off.
1.
For setting alarm time 1 with buzzer, press “ALARM1 / VOL –“ button (4) and
indicator (E) will flash. For setting alarm time 1 with radio, press “ALARM1 /
VOL –“ button (4) twice and
indicator (F) will flash.
2.
When the digits are flashing, press “HOUR / TUNING –“ button (5) repeatedly to
change the hour setting. Press “MIN / “ button (9) repeatedly to change
the minute setting.
3.
Press “ALARM1 / VOL –“ button (4) to confirm.
4.
To cancel alarm, press “ALARM1 / VOL –“ button (4) three times when the current
time is showing. The alarm indicators will be off.
5.
When the alarm sounds, press any button to turn off alarm or press “SNOOZE /
DIM / SLEEP” button (1) to enter snooze mode.
or
will blink during
snooze mode. Alarm will sound again after 5 minutes. Alarm buzzer does not cut
the radio sound. If alarm waken up by radio, volume control for radio is not
available.
6.
Follow the same instructions for alarm time 2 with “ALARM2 / VOL +” button (8).
