Dentech AYRDYNE, Инструкция по установке, эксплуатации и обслуживанию

Страница: 20 / 44

www.ayrdyne.com
FILTERS
OPERATION
20
3.2.1 PRIMARY FILTER
The Filters section contains screens related to filtering. Screens may vary based on system configuration.
PRIMARY FILTER DP
This numeric display and bar graph show the
filter differential pressure measured between
the dirty and clean sides of the filters.
LIFE
This bar graph shows the remaining life of
the filter.
PRIMARY FILTER STATUS
The filter status shows filter life. When the
filter is nearing end of life, it will remind you
to order or schedule the filter change. Once
the filter has reached end of life, it will prompt
you to change the filter.
CLEAN MODE SELECTION
This multi-selector sets the type of filter
cleaning performed by the system. There
are three types of cleaning: On Demand, On
1
2
ZERO METER
The Zero push button will zero the differential
pressure reading, should it wander from zero
over the lifespan of the differential pressure
sensor. This can only be done when the system
is not running. Additionally, the pneumatic
tubing should be disconnected from the
control panel.
SAVE, LOAD AND RESET
These buttons affect items on the displayed
screen only. The reset button must be held
until all indicators in the button turn blue,
approximately 3 seconds.
Save
Saves the settings for later use.
Load
Loads previously saved settings.
Hold To Reset
Resets settings to factory defaults.
a
b
c
5
6
3
4
3.2
3 4 6
7
8
9
10
11
12
5
1
2