If the Screen Below Displays After Replacement…
Displayed Message
Solution
“Set the current date and time.”
When the BHT power is turned ON after a long period of
non-use, you may need to reset the date and time.
If this error message displays on the screen, you need to
set the current date and time.
“Contact your administrator (XXXX)”.
If this message displays on the screen, reboot the BHT.
If this error persists, take a note on the error message
and then contact the system administrator.
Using the BHT after Long Non-Use
Data stored in the BHT may be lost or damaged and the calendar clock may stop if the BHT is left
unused for a long period of time.
・
Keep a backup copy of important or critical information.
・
Reset the calendar clock if it is stopped.
・
The battery cartridge is also used as a memory back-up power source. You should not remove the
cartridge from the BHT for at least 10 minutes until memory back-up power is fully charged.
P
lease refer to the User’s Manual
for more information on trouble shooting.
Troubleshooting Guide
Problem
The BHT is not turned ON
•
Make sure that the battery cartridge is properly inserted into the BHT.
•
Check the battery power level and charge the battery if necessary.
•
Wipe any dirt from the battery cartridge and BHT terminals.
Problem
The BHT cannot be charged.
•
Make sure that the dedicated battery charger is being used.
•
Make sure that the battery cartridge is properly inserted into the BHT.
•
Make sure that the BHT has been properly placed on the charger.
•
The BHT LED will turn red when properly placed on the charger.
•
Wipe any dirt from the battery cartridge and BHT terminals.
•
If the battery cartridge in use is an old one that has been repeatedly charged 300 times or more,
replace it with a new one.
Problem
The BHT accidentally turns OFF
•
Make sure that the battery cartridge has been fully charged. If not, charge the battery cartridge.
•
The BHT may be set to auto power OFF. If so, the BHT will automatically turn OFF when it is not used
for the specified period of time.
The auto power OFF setting can only be changed with the user program.
If the BHT cannot be tuned ON even after going through all the above measures, there is a possibility
that the charger is broken. Notify the system administrator.
Refer to the User’s Manual for appropriate measures if an error message is displayed on the BHT
during the operation.
-14-
