DEVICE INSTALLATION
The DAB+P device installation depends on the type of installation (temporary or
permanent) and type of connection used (FM or AUX).
Temporary installation:
Use the cigar lighter power connection if you don’t want to install the DAB+P so
that it could be removed easily later.
Please note:
If your cigar lighter connection
provides continuous power, it is recommended to disconnect the DAB+P device
each time when not in use to avoid battery discharge.
Permanent installation:
Use the included car side power cable and connect the
3 power leads
as follow:
• Red:
+12V Battery (permanent 12V)
• Purple:
+12V Switched (ACC or ignition)
• Black:
Ground (GND)
Using the DAP+P over FM
Connect the power cable (car side or cigar lighter) to the Dension DAP+P receiver
then plug the DAB antenna (passive or active with external power source) with SMB
connection. Finally connect the power (12V) wire for the active antenna (soldering
might be required) but this is only necessary if you are using an active aerial.
Using the DAP+P over AUX
Follow the same steps during the installation as before (FM) and connect the 3.5
jack-jack AUX cable also to the
AUX out
of DAP+P and
AUX in
of the radio (head
unit) after completing the above steps.
DAB+P installation diagram
* Schematic diagram of the installation
4
