Speakers used
4
ENGLISH
ENGLISH
Cable indications
The hookup diagrams on the subsequent pages assume the use of the following optional connection
cables (not supplied).
Audio cable
Analog terminal (Stereo)
R
L
R
L
Pin-plug cable
(White)
(Red)
Signal direction
Audio signal
IN
OUT
OUT
IN
Connecting the Audio Equipment
NOTE:
• Do not plug in the power supply cord until all
connections have been completed.
• When making connections, also refer to the
operating instructions of the other
components.
• Be sure to connect the left and right channels
properly (left with left, right with right).
• Do not bundle power cords together with
speaker cables. Doing so could result in
humming or noise.
• Do not turn up the volume when no turntable
is connected to the PHONO input terminals.
Doing so will cause humming or noise.
When not connecting a turntable, leave the
included short-circuiting pin plug plugged in.
Cautions on playing SA sources:
When regular speakers not compatible with SA
sources (DVD Audio discs, Super Audio CDs
and other sources including treble components
above the audible range), set the properties of
the player (DVD Audio player, Super Audio CD
player, etc.) for use with regular speakers (or
amplifiers).
The speakers may be damaged if the volume is
set too high when playing SA sources.
For instructions on setting the player, refer to
the operating instructions included with the
player.
Impedance
8 ~ 16
Ω
/ohms
Both A and B
Connections
Connecting the speakers
¢
Speaker impedance
Use speakers with impedances within the ranges
shown below according to their usage conditions.
4 ~ 16
Ω
/ohms
A or B only
Connect the speaker terminals with the speakers
making sure that like polarities are matched (
<
with
<
,
>
with
>
).
NOTE:
When making connections, take care that
none of the individual conductors of the
speaker cable come in contact with adjacent
terminals, with other speaker cable
conductors, or with the rear panel and
screws.
NEVER touch the speaker terminals when
the power is on. Doing so could result in
electric shocks.
Note on speaker impedance
When using speakers with an impedance
below the designated value (for example 4
Ω
/ohms), playing for long periods of time with
the volume high could cause the temperature
to rise, activating the protection circuit.
When the protection circuit is activated, the
output to the speakers is cut off and the power
indicator blinks. If this happens, unplug the
power cord, wait for the set to cool off and
improve ventilation around the unit. Also check
the wiring of the input cables and the speaker
cables. After doing this, plug the power cord
back in and turn the unit’s power back on.
If the protection circuit is activated again even
though there are no problems with the wiring or
the ventilation around the unit, switch off the
power and contact a DENON PROFESSIONAL
service center.
Connecting the speaker cables
1. Loosen by turning
counterclockwise.
Either tightly twist or terminate the core
wires.
2. Insert the cable.
3. Tighten by turning
clockwise.
