Playing CDs
This section uses playback from a CD as an example.
1
Press INPUT SELECT to switch the input source to
“CD”.
“CD” is displayed on the display of this unit.
2
Playback the CD.
3
Press VOLUME
df
to adjust the volume.
o
Playback in source direct mode
The signal does not pass through the tone adjustment circuitry (BASS,
TREBLE and BALANCE), resulting in playback of a higher sound
quality.
1
Press SOURCE DIRECT on the main unit to turn on
source direct mode.
The SOURCE DIRECT indicator lights.
o
Playback in analog mode
When the analog mode is turned on to playback an analog source
(PHONO, CD, NET/AUX, RECORDER, EXT.PRE), power to the digital
input circuit and the display turn off. This enables you to enjoy high
sound quality audio playback without sound quality being affected by
noise that occurs from the digital control circuit.
1
Press ANALOG MODE to turn analog mode on.
The ANALOG MODE indicator lights.
0
Press ANALOG MODE to toggle between “ANALOG MODE Off”,
“ANALOG MODE 1” and “ANALOG MODE 2”.
ANALOG MODE Off:
Analog mode is not used.
ANALOG MODE 1:
Turns the digital input circuit power off.
ANALOG MODE 2:
Turns the digital input circuit power and
display off.
0
A digital input source (COAXIAL, OPTICAL 1/2/3, USB-DAC) cannot be selected
when analog mode is on.
0
The input source automatically switches to CD if analog mode is turned on during
playback of a digital input source (COAXIAL, OPTICAL 1/2/3, USB-DAC).
0
Communication between this unit and the computer is disconnected if analog
mode is turned on when a computer is connected to the USB-DAC input connector
of this unit. If the unit cannot communicate with the computer after turning analog
mode off again, disconnect and reconnect the USB cable or restart the audio
player on the computer.
0
When the analog mode is switched, the mute circuit is activated for about 5
seconds.
27