11
Premier SP20005_REV_2
General Adjustments
SETTING THE CYLINDER
To set:
• Slacken 2-off lock nuts and bolts
(Item 1) [19mm spanner]
• Rotate bolt (Item 2) clockwise to bring the blade
towards the cylinder.
• Check the setting using thin paper along the length
of the cylinder.
• Adjust until it cuts along the whole length.
• When set, tighten the lock nut.
• Recheck adjustment.
• Do not set the cylinder hard to the bottom blade. This will cause excessive wear of both components and increase
fuel consumption.
• Recheck Adjustment.
Item 1
Item 2
DO NOT
SET THE CYLINDER HARD TO THE BOTTOM BLADE. THIS WILL CAUSE
EXCESSIVE WEAR OF BOTH COMPONENTS AND INCREASE FUEL CONSUMPTION.
NOTE
HANDLE BAR ADJUSTMENT
The
“Handle bars”
are adjustable to achieve the
correct working height for the operator.
To set:
• Remove bolt (Item 1) [9/16” spanner]
• Rotate handle into required position.
• Replace bolt (Item 1) [9/16” spanner]
Item 1
