Dennard dtx400/dc
UP THE COAX CONTROL
The controller telemetry will out-put
BBV protocols
The 2055 Dome address switches need to be set to
DEN PANEL
See page 10 of the Dennard 2055 product guide, supplied with each Dome.
(
Blue
rotary address switch set to
F
….
Yellow
rotary address switch set to
D
)
This is the default setting for Type 2055 domes unless specified otherwise.
NB If the dome is a 2055/drx ( remote protocol converter in the PSU box ) then
the address switches will be factory set to : Yellow = 0 Blue = 1
STORING PRESET POSITIONS:
(It is quicker to use the Dennard controller software rather than using the 2055 Dome
software )
NB The dtx1000 uses on screen menu display which is only available if the monitor
is connected to the keyboard, simple programming options like setting preset
position can be programmed in without the ability to see the menu display
Move camera to desired position.
Press and hold the
set
key then press the number key you want to use to identify the
preset.(only eight preset positions can be set using this controller)
At this stage the preset menu from the dome will be displayed on the screen enabling you
to key in a preset identification. Text can be entered by moving the cursor under each
letter/number in turn using the joystick then pressing key number
1
to accept.
When you have finished entering text close the menu by moving the cursor down to the
Accept edit
line and accept by pressing key number
1
.
If you don't want to add a preset identification move the cursor down to the
Accept edit
line and accept by pressing key number
1
.
.
2055 PROGRAMMING
:
To access the dome menu
Press and hold the
shift
key then press No
1
key
This will give you access to the operator menu. The
Supervisor menu (pin number
1111)
and
Technicians menu (pin number 9999)
can be accessed from this menu. The
number
1
key
is used to enter/accept.
2055
Menu
System Manual
Appendix 1
Sheet.A1-6
