DenMat PeriOptix, Инструкции, гарантия и уход

Страница: 3 / 7

If you have questions, please call customer service at 1-888-360-0033. If you have questions, please call customer service at 1-888-360-0033.
A
B
C
3. Loupe Adjustments
A. Declination angle
B. Convergence angle
C. Interpupillary Distance
(distance between the pupils)
4. Disassembly
Your Hogies loupe system comes
assembled with the magnetic hinge
securely attached to the magnet by
two set screws. To remove the loupe
optics from the magnet, first loosen
the set screw(s) closest to the frame.
(Do not loosen the set screw further
from the frame. Refer to illustrations
5.2a and 5.2b). These are located at
the 10 and 2 0’ Clock position on the
magnetic hinge.
5. Assembly
5.0 Place safety shield on loupe
frame by aligning two pilot holes
with pins on frame. Shield should
snap over pin. Note: shield will not
remain in place without magnetic
hinge. Hold in place with thumb
and forefinger while attaching loupe
optics.
5.1 Attach magnetic hinge. Be sure
shield and hinge seat completely
onto the frame.
5.2a The loupe optics should be
securely locked to the frame with the
supplied allen wrench.
5.2b Once the loupe optics are
attached, use the short leg of the
allen wrench to tighten the set
screw(s) on the hinge closest to the
frame. Tighten the set screw until
initial resistance is felt and then
tighten for another 1/3 of a turn.
5.1 5.0
5.2b 5.2a