DENIA DC-70, Инструкции по использованию и обслуживанию

Страница: 7 / 34

This model is equipped with a tangential fan (170 m3/h). It takes the air in the lower
part to circulate in the woodstove and share it out from the top part.
The fan has a thermostat to regulate the temperature. It starts to 50ºC to prevent overheating
The woodstove has an electric switch with three positions to regulate the hot air flow rate.
- In position 0, the fan is off but if the temperature reach 50ºC, the thermostat let
the fan starting, on the position I
- In position I, the fan reach 60% of the maximum speed.
- In position II, the fan reach the maximum speed.
7
PROPERTIES OF THE FAN
Since this device has been tested in a homologated laboratory and since we check our
devices a full 100%, making sure that the electric wiring operates correctly before shipping,
the fan and the electric wiring are not covered by our warranty.
IMPORTANT: The fan must be ALWAYS connected to the network to prevent overheat to
deterioration
Mod.
D C - 7 0
the device, glass and smoke outlet.
FUEL
- Use only dry wood with a maximum moisture content of 20%. Wood with a moisture
content higher than 50 or 60% does not heat and combusts very badly, and creates
a lot of tar, releases excessive amounts of vapour and deposits excess sediments onto
- The fire should be lit using special fire lighters, or paper and small pieces of wood.
Never try to light the fire using alcohol or similar products.
- Do not burn domestic rubbish, plastic materials or greasy products that can pollute
the environment and lead to risks of fire due to obstruction of the pipes.