DENAVO DHS-700RX, Руководство пользователя

Страница: 8 / 29

- 8 -
Chapter 2 Setup
1. Protocol Setup
The dome camera supports multi-protocol. Set the protocol via DIP switch (refer to the below
diagram.). Please confirm if the protocol is correct before using. The SX Model's DIP switch is on the
top of pan/tilt module, and the other Models' DIP switches are on
Corresponding diagram of protocol and code(if 8 switches, the last two are vacant)
：
No.1 code switch: selectable switch for 120-ohm adapter resistance of communication line. Last high
speed dome should be connected with adaptable resistance in the same line. Put No.1 to ON and don't
connect the other high speed dome with adaptable resistance side by side, put No.1 to OFF.
No.1 code switch 2, 3 is baud rate switch.
No.1 code switch 4, 5, 6 is Protocol switch.
2. Address Setup
Each high speed dome corresponds an address code. More intelligent
and high speed dome can be connected in the same control system.
Address code must be different, otherwise result in a conflict and
mistake operation. Select a certain high speed dome firstly while
controlled.
Address code is selected through S2 switch
Address Switch