PARTS LIST:
4 U-Bolt, 5/16-18x1.5”x2.69” (Fastenal: 42018)
8 5/16 Lock Nuts
8 5/16 Washers
1 Frame Mount, King Quad
INSTALLATION
1.
To install the plow mount to the underside of the
vehicle, remove the factory skid plate. This will
require the use of a 10mm socket, as shown in Figure
2.
2.
Once the skid plate is removed. Use the plow
mount as a template for holes to be drilled, as shown
in figure3.
3.
Place the plow mount 6” in front of the circular
hole in the skid plate, as shown in figure 4.
4.
Place the edge of the plow mount 3/16” away from
the edge of the skid plate. The opposing edge of the
plow mount will hang partially over the edge of the
skid plate. Make sure the plow mount is
perpendicular to the skid plate. Mark all hole
locations on the skid plate by scribing the plastic with
a sharp object. Using a 11/32” drill bit, drill through
the skid plate, as shown in figure 5.
5.
Reinstall the skid plate with the six fasteners
removed in step 2. Install the plow mount with the
provided fasteners by placing the U-Bolts over the
frame with the threaded ends protruding through the
plow mount. Attach the 5/16” washers and nuts as
shown in Figure
6. It is important that all fasteners are loosely
installed until final assembly. It may be necessary to
slot the hole locations on the skid plate for the U-
Bolts to line up with the skid plate. The picture
shown is from the rear of the bike looking forward.
7.
Tighten all fasteners securely. Torque 5/16” bolts
to 20ft. lbs.
8.
If you haven’t already done so, assemble the plow
per the instructions included in the plow kit. Attach
the plow to the mount using the pins provided in the
plow kit.
REMOVE SIX BOLTS
SKID PLATE
FIGURE 2
FIGURE 3
