1. Installing The Compressor
DENALIELECTRONICS.COM
Step Five:
Route the hose down the left side and underneath the bottom of the
compressor, then wedge it in the gap between the right side of the compressor and the
bracket. The remainder of the hose should be channeled up under the side fairing and
forward through towards the front shock. Once through to the front, the hose end
should be routed up behind the steering head through the tubular frame sideways
towards the right side where it can be connected to the acoustic unit.
Step Six:
Route the horn wiring harness down into the same channel between the right
side of the compressor and the bracket where the hose is wedged. Connect the wire
leads to the bottom of the compressor when ready.
1.3 - Installing The Compressor
Step One:
Install the hose end onto the compressor, making sure it is all the way on and
secure.
Step Two:
Use the horn provided hardware (M8 Hex bolt, M8 Nut) and a 13mm wrench to
secure the compressor to the Bracket (g).
Step Three:
Locate both of the mounting points on the engine case on the left hand side of
the bike and remove the factory bolts.
Step Four:
Mount the Compressor Bracket (g) and compressor to the mounting locations
using the two M6x30mm screws (e) and two M6 Washers (f).
