6. DataDim™ Controller Upgrade
6.1 - DataDim™ Controller Overview
DENALI 2.0 Light pods are equipped with a dedicated 3rd-wire dimming
circuit so we can use an external signal to reliably control the intensity
of the LED chip at the source. Plug in our Dual-Intensity DataDim™
Controller to enable the DENALI lights to switch between half and full
intensity with your vehicle’s original high beam switch.
Step One:
Unplug the Single-Intensity Relay from the Base Harness.
Step Two:
Plug the Dual-Intensity DataDim™ Controller into the Base
Harness.
6.2 - Tapping The High Beam
Step One:
Plug the blue Dual-Intensity Trigger wire into the bullet
connector at the base of the On-Off Switch.
Step Two:
Use a test light while toggling the vehicles high beam switch
to identify the wire which receives power upon high beam activation.
Step Three:
Once the high beam trigger has been identified, use the
included Posi-Tap to tap into the wire.
Note:
Some vehicles are equipped with LED headlights or other lighting
systems that do not provide a clean 12v high beam trigger signal. See
Figure 7.1
for an overview of our independent dimming switch.
7. Switching Options
DENALIELECTRONICS.COM
7.1 - Hi-Low-Off Switch Option
The DENALI Hi-Low-Off Switch enables independent dimming of the
lights, separate from the vehicles OEM lighting system. This eradicates
the issues presented by vehicles that do not provide and a clean 12v
high beam trigger signal. This switch is also a great option for those who
want full independent control of their auxiliary lights.
Note:
The Dual-Intensity DataDim™ Controller option is required to
install this switch.
Step One:
Unplug the standard On-Off switch from the base harness.
Step Two:
Plug the Hi-Low-Off Switch into the base harness.
7.2 - Switch Eliminator Option
The DENALI Power Switch Eliminator plug replaces the standard On-Off
switch so your lights will automatically power on and off with the
vehicles ignition. Enjoy the convenience of having your lights on any
time your bike is running and peace of mind knowing they will turn off
with the ignition.
Note:
This switch eliminator removes the ability to independently shut
the auxiliary lights Off while the vehicle is running.
Step One:
Unplug the standard On-Off switch from the base harness.
Step Two:
Plug the Switch Eliminator into the base harness.
DataDim™ Controller
Base Harness
Single-Intensity Relay
On-Low-Off Switch
Switch Eliminator
Base Harness
Base Harness
Posi-Tap
Bullet Connector
On-Off Switch
