3. Connecting Accessories
3.1 - Light Set One & Two - (Red & White Circuits)
In the default configuration, the circuit for Light Set One is the longest red
lead, the shortest white lead is for Light Set Two. Both circuits are designed
to handle up to 10 amps each.
Step One:
Plug the male 3-pin connector of the Light Extension-Splitter
into one of the CANsmart™ Controller’s light circuits.
Step Two:
Begin routing the harness toward the front of the bike. Secure
the harness to the vehicle’s frame along the way with the included zip ties.
Be sure to avoid any moving components such as radiator fan blades or
suspension.
DENALIELECTRONICS.COM
2. Connecting To CAN bus & Battery
2.1 -
Connecting To The CAN bus
Step One:
Locate your bikes Diagnostic Port. The port is a red 6-pin
female connector. In general the connector is located
underneath the riders seat. For the exact location, check your bikes
owners manual.
Step Two:
Remove the cap.
Step Three:
Next connect the male CAN bus connector on the
CANsmart™ Controller to the Diagnostic Port.
2.2 -
Connecting To The Battery
Step One:
Remove the fuse from the fuse holder.
Step Two:
Gain access to the vehicle’s battery and disconnect the
negative (-) and positive (+) terminals.
Step Three:
Connect the CANsmart™ wiring harness to the battery via
the ring terminals. Be sure the orange wire lead with the fuse holder
goes to the positive (+) terminal of the battery.
Step Four:
Re-install the fuse into the fuse holder.
Note:
Place the fuse holder in an easily accessible location for
convenient service in the event of a blown fuse.
Step Three:
Plug the DENALI Light Pods into the female 3-pin connec-
tors of the Extension-Splitter. Repeat steps
One
through
Three
using a
second Light Extension-Splitter for the second set of lights.
Two-Wire Dimming:
Turn off “Three-Wire Dimming Mode” for correct
dimming operation of auxiliary LED lights that have only two wires. If
enabled the 3rd yellow wire will be deactivated and PWM data will
instead be transmitted through the red wire.
Wire two wire lights using the red wire for positive (+) and the black
wire for negative (-).
Horn Extension
Light Extensions
Vehicle CAN bus
Connector
CANsmart CAN bus
Connector
CANsmart™
Brake Light Wiring Adapter
Positive Terminal
Battery
Negative Terminal
Light Set One
Light Set Two
Light Extension
Light Extension
