Demon Tempest 1, Инструкция по эксплуатации, Страница: 7 / 56

PREPARATION
a. Connect hose to water inlet connector and turn on.
b. Connect high pressure hose to connector.
c. Connect lance to hose.
d. Connect plug to suitable RCD protected supply and turn on.
e. Top up fuel levels and check oil levels in pump and engine.
f. If chemical is to be used place filter in drum of chemical and open valve. If not
make sure valve is closed.
OPERATION TO START MACHINE
a. Push blue switch once to start the engine.
b. Pull trigger until operating pressure is reached.
c. Push red switch once, burner will then operate.
d. Burner will then ignite once trigger is pulled.
OPERATION TO STOP MACHINE
a. Close the chemical valve if opened.
b. Switch to cold by pressing red button once and run the machine until the water
turns cold.
c. Switch off by pressing blue button once.
d. Pull trigger to release excess pressure and disconnect from machine.
e. If the machine is to be stored, drain water system and top up the fuel and oil levels.
IF IN DOUBT ASK ‐ OUR ADVICE IS FREE