Water Supply:
a.
Ensure there is an adequate water supply either from the mains or a reservoir.
b.
Attach water supply hoses to suitable tap or immerse end of hose into reservoir.
(The 110 mesh filter supplied should be used when sucking from a reservoir
.)
NOTE: ONLY CLEAN FILTERED WATER SHOULD BE USED.
Hoses:
a.
Attach the high pressure hose to the pump connection.
b.
Attach the spray gun to opposite end of the high pressure hose.
c.
Ensure that the regulator nozzle on the end of the spray lance is
CLOSED.
OPERATION
(Check that electric motor is switched
‘OFF’
)
a.
Plug into a suitable electrical source. (Not an extension lead)
b.
Turn on water supply.
c.
Ensure that the trigger is
‘OPEN’
to vent air from the pump.
d
.
Switch
‘ON’
electric motor.
e.
Open regulator nozzle slightly and direct lance on surface to be cleaned. Press
operating trigger
.
f.
Adjust pressure regulator as required to obtain working pressure.
g.
NOTE: The high pressure water will cause the gun to ‘kick’. Make sure you have a
firm grip of the gun and lance.
h.
On completion of the operation switch
‘OFF’
electric motor and unplug from power
supply.
i.
Turn
‘OFF’
water supply.
j.
Release residual pressure in gun and lance by operating trigger.
Preparation
Содержание HURRICANE D1 SALT WATER
