Demco SIDEQUEST, Руководство оператора

Страница: 15 / 20

Page 15
7.
Using a fork lift, lower tank assy down onto Spindle Housing.
Install 3/4” bolts and nuts into Spindle Housing. Leave bolts loose.
8. Install Extension Arm onto Overhead Arm using (4)
5/8” bolts, lockwashers and nuts. Install (2) Slide Tubes
Assemblies onto Extension Arm.
9. Line up Drop Channel holes to the holes on front of
Tank Assembly. This will vary depending on type
of tractor and wheel base. Install (4) 5/8” bolts,
lockwashers and nuts.
11.
Install (4) 1/2” set screw and jam nut in each Spindle
Housing and (2) in each Slide Tube Assembly.
12. Tighten all bolts and set screws.
13. Repeat same instructions for the opposite side.
14. To remove tanks:
Remove 5/8” bolts from overhead and 3/4” bolts from •
spindle housing.
Lift tank vertically until clear of spindle housing
•
Remove hub/spindle assy from spacer (see step 4) •
Optional - remove overhead using pin to release •
Note: keep overhead arms separate as left or right
10. Attach a Drop Channel to each Slide Tube Assembly.
Use (4) 5/8” bolts, lock washers and nuts.