DEMAG DC-Com 1, Руководство по эксплуатации

Страница: 49 / 116

5.10 Programming parameters with the control pendant
5.10.1 General
Parameters can be programmed to adapt the chain hoist to specific application requirements. The parameters
can be programmed using the control pendant together with the 7-segment display on the underside of the chain
hoist.
5.10.2 Meaning of the buttons
Fig. 26
1 "Lift" - Accept selection 2 "Lower" - Move to next parameter or se‐
lection value
3 "Emergency stop" - End parameter pro‐
gramming (changes are saved)
Tab. 31
5.10.3 Meaning of the parameters
From software version SW 2.10, the following parameters can be programmed:
Display of parameter no. Parameter name Display of parameter value Remark
0 -
1 -
2 Hoist only V2 speed
n.
Default
V1/V2
Y. V2
3 Lock the control pendant
n.
Default
Control pendant is locked when several keys are actuated.
Y.
Priority is given to the first button that is pressed if the lifting and
lowering buttons are actuated together.
4
Time-controlled start-up
(e.g. for tandem operation)
n.
Default
Speed-dependent start-up
Y. Time-controlled start-up
5 -
6 -
7 -
8 -
9 -
Tab. 32
214
80
2 44/291
113
49