IP67 LED STRIP KIT
(SINGLE COLOUR)
FITTING
INSTRUCTIONS
DEL0591g/Feb_2017/issue_3 page 2 of 2
www.delucelighting.com
Cutting the LED Strip Light
The LED Strip can be cut at 50mm intervals and can be relinked using either a connect clip, a double ended connector cable c/w
150mm of cable, single ended connector clip c/w 150mm of cable or by soldering a cable between the LED Strip Light's copper
connectors (all connectors supplied with kit).
Cut the LED strip at the designated cutting line, marked with a
✂
its is recommended that a suitable craft knife is used to cut the
LED Strip Light.
Once cut; use the craft knife to remove the outer plastic sleeve, as close to the nearest LED light, near the cut as possible to expose
the copper connectors ( & – ).
Slide a piece of heat shrink over the end of the LED strip - open a flap on a connector clip / connector cable - slide the now cleaned
end piece into one side of a connector clip / connector cable and then using a soldering iron,
YOU MUST
solder the connector
clip's terminals to the LED strips copper connectors in turn.
Or solder a piece of cable between the LED Strip Light's copper connectors as follows :
RED
(Po to Po)
BLACK
(Negative – to Negative –)
Using the supplied glue, glue down the flap(s) of the connector clip; then slide the heat shrink sleeve over the now finished connection
(using a Hair Dryer) heat the heat shrink until it contracts sufficiently.
Over the tailing end of the LED strip light fit an End Cap ( apply a small amount of glue to the inside of the end cap and then slide
over the tailing end area ).
Then follow the steps 1 - 7 for installation.
IP67 LED Strip Accessories
Ref no.
Qty
Description
IP67LEDSTRIP90B
1
IP67 LED Strip Single Colour 90 Degree Bend
IP67LEDSTRIPCLIP
1
IP67 LED Strip Mounting Clip
IP67LEDSTRIPEC1
10
IP67 LED End Cap For Single Colour Plus Glue
Ref no.
LED Colour
Length
No. of
LED’s
IP67LEDSTRIP3MWH
Cool White
3M
180
IP67LEDSTRIP3MWW
Warm White
3M
180
IP67LEDSTRIP3MR
Red
3M
180
IP67LEDSTRIP3MG
Green
3M
180
IP67LEDSTRIP3MB
Blue
3M
180
3M ADD-ON LED STRIPS
Ref no.
Qty
Description
LEDSTRIPACC001
5
10mm Single colour strip connector
c/w 150mm of wire
LEDSTRIPACC002
5
10mm Single colour strip connector
LEDSTRIPACC003
5
10mm Single colour strip link
c/w 150mm of wire - connector at each end
LEDSTRIPACC003
POLARITIES MUST BE MAINTAINED
LEDSTRIPACC002
PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLATION
LEAVE A COPY FOR THE USER/MAINTENANCE ENGINEER FOR FUTURE REFERENCE
We recommend this fitting is installed by a qualified Electrician.
