5
CHARGER FUNCTIONS/MODES
OUTPUT POWER MODE DETAILS
1. 1.25A CHARGE: This mode will charge and maintain a 12 volt
battery for long periods of time. This function is completely
automatic and will never over charger your battery. The charger
output power, voltage, and current depends on the condition of the
battery it is charging.
2. 20A BOOST: This mode will Boost the battery at a maximum rate
of 20Amps until the battery voltage increases to approximately
14
volts. When the battery voltage reaches the target, the charger
then exits the Boost mode. Li-Ion batteries are not supported in this
mode.
6
3. 75A ENGINE START: This mode will first use 10Amps to
increase the battery voltage to at least 10.5 volts. Once the
battery reaches 10.5 volts, the charger is ready for an engine
start. If the voltage is less than 9 volts, the charger assumes
the key has been turned. Now the charger applies up to
75Amps to assist starting the engine. After five (5) seconds,
the charger will stop the 75Amp current and
go into cool down
mode for two (2) minutes. Li-Ion batteries are not supported in
this mode.
4. POWER SUPPLY: This mode provides low voltage DC current
of one (1) Amp at 13 volts. The Power Supply function is for
use as only a memory saver when changing out a battery.
5. WARNING/ERROR LED:
There are safety timers built into the
charger which vary depending on which battery type you have
selected. These timers will prevent a bad battery from being
over charged if it does not reach optimum voltage within these
time frames. Have your battery checked if this occurs. This
LED also indicates if the charger alligator clips are connected
backwards to the battery (reverse polarity). Lastly, if this LED is
blinking, this is the indication the WiFi is off. Refer to the WiFI
section to turn it back on.
CHARGER OPERATION
1) POWERING UP: When you first plug the charger into a power
outlet, all of the LED’s and battery level lights will illuminate for
about two (2) seconds.
2) FUNCTION SELECT: To select an output mode, (example 20A
Boost) simply press and hold the select button down for three (3)
seconds to change modes and scroll through the selections.
3) BATTERY TYPE SELECT: To change the battery type, a short
press will change the battery type and scroll through the selections.
4) OUTPUT MODE LED OPERATION: Once a battery is connected,
the charger can either be in active or idle mode. When the LED is
blinking, the charger is in idle mode, and the output is off. When
the LED is solid, the charger is in active mode and the output is on.
