background image

9

  

 

5)  Turn the power switch on.  Before attempting to start the engine, make 

sure that the Jump Starter and the battery clamp cables are clear of 
any metal parts and any moving parts in or around the engine 
compartment.  

6)  Start the engine for 3 seconds or until the engine starts, whichever 

comes first.  Do not crank the engine for longer than 3 seconds.  See 
the following warning. 

 

 

!     WARNING: Fire Hazard 

The Jump Starter engine start function is designed for short term operation, 2–3 
seconds, or less.  Continuing to operate the engine start function for longer than 
3 seconds may cause damage to the Jump Starter unit.  

Allow the Jump Starter to cool down for at least 3 minutes after each continuous 
3 second attempt to start the engine, whether or not that attempt is successful. 

7)  Turn the power switch to the “OFF” position. 

8)  Disconnect both of the battery cable clamps from the vehicle battery IN 

THE OPPOSITE ORDER THAT YOU CONNECTED THEM TO THE 
BATTERY AND TO THE VEHICLE CHASSIS. First disconnect the 
BLACK Negative (-) clamp and clamp it back on its holder on the Jump 
Starter case.  Then disconnect the RED Positive (+) clamp and clamp 
it back on its holder on the Jump Starter case.

 

5.  Recharging the Jump Starter internal battery 

NOTE: 

Recharge the Jump Starter internal battery as soon as possible after each use.  
When the Jump Starter is not being used for extended periods of time, the 
internal battery should be recharged every 3 months. 
The Jump Starter internal battery must not be recharged through the 12V DC 
socket. 
Make sure that there are no 12V DC appliances connected to the Jump Starter 
while the internal battery is being recharged. 
 

 

10

  

 

 

!     WARNING 

The Jump Starter must not be recharged through the 12V DC socket. 
 

!     WARNING 

Make sure there are no 12V DC appliances connected to the Jump Starter during 
charging.

 

Recharging the internal battery with the AC charger with coax adapter 

1)  Ensure the Jump Starter ON/OFF switch is in the “OFF” position. 
2)  Plug the AC coax adapter into the charger input socket on the Jump 

Starter. 

3)  Plug the AC charger into AC electrical outlet. 
4)  Whenever possible, do not stop charging the internal battery until it is 

fully recharged.  This could take 24 to 30 hours, or more, depending 
upon the state of charge and the general condition of the internal 
battery when you begin to recharge it. 

NOTE: 

Once fully charged, the charging current automatically drops to a floating charge 
mode, and the unit may be left permanently connected to the AC charger.

 

6.  12V DC Outlet (Power Port) 

The 12V DC Power Port cylindrical connection is located on the front of the unit, 
on the top left just below the carrying handle. It is perfect for a wide variety of 
electric or electronic appliances that have a cigarette lighter type adapter and 
require 12V DC input power. 

NOTE: 

A 12V cigarette adapter is not supplied with this unit. 

It is recommended that you do NOT power any accessories that draw more than 
8 Amps. Ensure the cigarette adapter you are using is properly rated. 

7. Maintenance 

and 

Care 

Routine maintenance is recommended to keep the Jump Starter in good working 
condition. 

CLEANING 
Occasionally clean the exterior of the case to remove dust, dirt, and other 
sediment that may accumulate over time. 

Содержание Battery Tender 030-0006








Отзывы: