DeltaTRAK FlashCheck 12237, Руководство пользователя

Страница: 6 / 12

3 www.deltatrak.com
• High-Low Alarm
The LCD displays the current temperature reading and the High and Lo
alarm set points.
Note: High-Low Display Mode is only available when the Alarm option
is enabled in the Configuration menu (see below)
Changing the Display Mode
Click the Mode button to switch between the two display modes.
Resetting the Max-Min Memory
While in Max-Min display mode with no Alarm indication click the Clear button.
The Max-Min memory is cleared and the
Reset icon is displayed until the next sensor
reading is taken.
Note: During Alarm indication the first click of
the Clear button will cancel the Alarm indication.
Click again to reset Max-Min memory.
Alarm Indication
Alarm indication must be enabled in the configuration
menu and the High Low Alarm set points must be
set. When the sensor’s reading exceeds the Alarm set
points, Alarm condition occurs. The device will indicate
Alarm by displaying the Bell icon and a flashing red
LED behind the icon. At the same time the HIGH or
LOW icon text will be flashing, showing which set point
was violated. If the alarm sound option is enabled in
the configuration menu, the device will also beep when the red LED flashes.
Note: The Alarm indication will continue until it is canceled by the Clear button.
Clearing the Alarm Indication
During Max-Min or High-Low display mode click the Clear button. The Alarm indica-
tion is reset until the sensor reading is again above or below the High or Low alarm
setpoints respectively.
Configuring the Thermometer