6
FRONT GUIDE RAIL
1.
Align the four holes in the front guide rail (not shown)
with the four holes in the front of the table.
2.
Insert an M8-1.25 x 30mm flat head screw through
the hole in the front guide rail and the table.
3. Place an 8mm flat washer and a 8mm lockwasher
on the screw. Thread an M8 x 1.25 hex nut on the
screw. Repeat this process for the remaining three
holes in the front guide rail and the table.
4.
Use a square (D) Fig. 4 to make sure the front guide
rail is parallel with the table and tighten the hardware
that holds the guide rail to the table.
GUIDE TUBE
1. Align the holes on the bottom of the guide tube (C)
Fig. 6 with the holes on the front guide rail (D).
2. Place an 8mm lockwasher on an M8 x 1.25 x 16mm
hex head screw (A) Fig. 5. Insert the screw through
the hole in the front guide rail (D). Thread the screw
into the tapped hole in the bottom of the guide tube
(C) and tighten securely.
3. Repeat this process for the five remaining holes in
the front guide rail and the guide tube.
A
Fig. 3
Fig. 4
Fig. 6
Fig. 5
B
D
C
D
A
NOTE:
The front and rear guide rails have three holes (A)
Fig. 5 in the extension end that are used to attach an
extension table. If you plan to install an extension table
to your machine, install it before attaching the guide
tube.
A
FOR MODEL 36-729 ONLY
1. Align the two holes in the front guide rail (A) Fig. 3
with the two holes in the front of the table.
2. Insert an M8-1.25 x 30mm flat head screw (B) Fig. 3
through the hole in the front guide rail and the table.
3. Place an 8mm flat washer and a 8mm lockwasher
on the screw. Thread an M8 x 1.25 hex nut on the
screw. Repeat this process for the remaining hole in
the front guide rail and the table.
4. Use a square (D) Fig. 4 to see if the front guide rail
is parallel with the table. Tighten the two screws that
hold the guide rail to the table.
FOR TABLE SAWS WITH SHEET METAL EXTENSION WINGS - T
2
-30 ONLY