9
3.
Insert raising rack (F) Fig. 6, which was removed in
STEP 1
, into groove in table bracket making sure teeth
of worm gear (G) located inside table bracket are
engaged with teeth of raising rack (F).
Fig. 6
F
G
4.
Slide raising rack (F) Fig. 7, table and table bracket onto drill press column, as shown. Make sure bottom of raising
rack (F) Fig. 8, is inside the flange (J) on drill press base.
Fig. 7
Fig. 8
F
F
J
5.
Re-assemble ring (E) Fig. 9, which was removed in
STEP 1
.
IMPORTANT
: Bottom of ring (E)
MUST NOT
be pushed
all the way down onto top of raising rack (F).
MAKE SURE
top of raising rack (F) is under bottom of ring (E) and that there
is enough clearance to allow rack (F) to rotate around the column.
THEN TIGHTEN SET SCREW (D) BEING CAREFUL
NOT TO OVERTIGHTEN.
Fig. 9
D
E
F
6.
Assemble table raising and lowering handle (K) Fig. 10, to worm gear shaft (G) and tighten screw (L) against flat on
shaft.
Fig. 10
G
L
K
