8- ENG
D27930
GLOSSARY
Become familiar with these terms before operating the unit.
CFM: Cubic feet per minute.
SCFM: Standard cubic feet per minute; a unit of measure of air delivery.
PSIG: Pounds per square inch gauge; a unit of measure of pressure.
Code Certification: Products that bear one or more of the following marks:
UL, CUL, ETL, CETL,
CSA/US
have been evaluated by OSHA certified
independent safety laboratories and meet the applicable Underwriters
Laboratories Standards for Safety.
CSA: Electrical products sold in Canada are required to be certified to the
applicable CSA standard (s). Canadian Standards Association (CSA) is a
standards writing and safety testing organization. Products that are CSA
certified have been evaluated and tested and found to meet or exceed the
applicable CSA standard (s) for safety and electrical performance.
Cut-In Pressure: While the motor is off, air tank pressure drops as you
continue to use your accessory. When the tank pressure drops to a certain low
level the motor will restart automatically. The low pressure at which the motor
automatically restarts is called “cut-in” pressure.
Cut-Out Pressure: When an air compressor is turned on and begins to run,
air pressure in the air tank begins to build. It builds to a certain high pressure
before the motor automatically shuts off - protecting your air tank from
pressure higher than its capacity. The high pressure at which the motor shuts
off is called “cut-out” pressure.
Branch Circuit: Circuit carrying electricity from electrical panel to outlet.
Model No.
CP200
Voltage/Hertz/ Phase
120V/60/1
Minimum Branch Circuit Requirement
15 amps
*Fuse Type
Time Delay
Air Tank Capacity
2 gallons
Approximate Cut-in Pressure
75 PSI
Approximate Cut-out Pressure
100 PSI
SPECIFICATIONS
* A circuit breaker is preferred. Use only a fuse or circuit breaker that is the same
rating as the branch circuit on which the air compressor is operated. If
compressor is connected to a circuit protected by fuses, use only time delay
fuses. Time delay fuses should be marked “D” in Canada and “T” in the US.