1
2
3
5
6
4
Determine the correct distance required between
the two pulley hooks
(e.g. handlebars to back of seat on a bicycle).
Securely tie a double knot in the end of the cord and feed the
remaining cord throught the hole on the end of the pulley unit
that does not have the cord locking mechanism. The knotted
end will then be between the ceiling and the pulley bracket.
Using screws provided, carefully mount each pulley into the
ceiling joist at the correct distance so the hooks will line up
(as measured in 1). Important; ensure that the 2 screws on
each pulley are securely mounted into the joist. Pre-drilling
1/8” pilot holes will make this job easier.
Locking
Locking
Thread the cord through the pulleys as shown. Be sure to
carefully thread the cord down through both parts of the
locking mechanism.
Mount the cord cleat at a
safe height out of reach
of small children and screw
directly into a stud using two
wood screws supplied.
When item is raised to the
desired height, the excess
rope should be stored around
the cleat
Do Not Cut Excess Cord.
Raising an item
Raising an item
Lowering an item
Lowering an item
Keeping the tension in this direction, slowly let the cord out as the item lowers.
Once low enough, remove item from the hooks and wrap the cord back on the cleat.
USAGE INSTRUCTIONS:
WALL STUD
WALL STUD
CEILING JOIST
CEILING JOIST
Back Single Pulley
Back Single Pulley
Knot
Knot
Front Double Pulley
Front Double Pulley
Ensure the hooks are properly secured on the item and the cord is not twisted before pulling on the cord.
The auto-locking device will hold the item suspended with each pull.
Once hoisted to the correct height, wrap the excess cord securely around the cleat.
Knot
Knot
Locate the ceiling joist. Transfer the distance measurement
(Step 1) so that the pulleys line up to the correct distance
along the joist (Note: It is also possible to mount the pulleys
first onto a board which can then be securely mounted to
joists as illustrated).
050222
Service:
Please do not return to store;
for immediate response email
Delta Cycle Corporation
36 York Avenue, Randolph, MA 02368 USA
800-474-6615 / www.designbydelta.com
