Delta D1600e, Инструкция по эксплуатации

Страница: 7 / 14

7- ENG
D27665
HOW TO USE THE CHEMICAL
APPLICATION UNIT
NOTE: Use only soaps and
chemicals designed for pressure
washer use. Do not use bleach.
1. Place the ON-OFF switch in the
OFF position.
2. Turn off the water supply.
3. Remove chemical application unit
from holder.
4. Fill the tank of the chemical
application unit with detergent.
5. With wand removed attach
chemical application unit to gun as
shown.
6. See Before Starting and Starting
Your Pressure Washer paragraphs
in this section to continue.
Figure 2
HOW TO USE THE HIGH
PRESSURE SPRAY WAND
The nozzle at the end of the wand can
be rotated to change from narrow jet
stream to fan jet, as shown.
For low pressure operation, pull the
nozzle at the end of the wand out as
shown.
For high pressure operation, push the
nozzle at the end of the wand in as
shown.
Glossary
Ground Fault Circuit Interrupter
Protection (GFCI):
This washer is
provided with a ground fault circuit
interrupter (GFCI) built into the plug of
the power supply cord. This device
provides additional protection from the
risk of electric shock. Should
replacement of the plug or cord
become necessary, use only identical
replacement parts that include GFCI
protection.
Total Stop System: This unit is
equipped with a total stop system.
When the trigger is released the motor
is shut off automatically. When the
trigger is pressed again the motor will
automatically start. The time between
release and engagement must not be
less than 4-5 seconds. DO NOT leave
the unit in automatic stop mode for
more than 15 minutes.
Figure 3
Figure 4
fan jet
jet stream