2
PACKAGE CONTENTS
PART DESCRIPTION
APPEARANCE
QTY
1
Fan Body
1
2
Grille
1
3
Duct Connector
1
ASSEMBLY INSTRUCTIONS
NEW CONSTRUCTION –
ATTACHING TO THE JOIST
BEFORE INSTALLATION
Turn off power source. Review all safety precautions.
1. Attach the Duct Connector
3
to the Fan Body
1
❶
1
2. Remove the wiring box cover from the Fan Body
1
.
Remove the wiring knockout from the wiring box
cover with a flathead screwdriver (not included).
❶
2
3. Place the Fan Body
1
next to a ceiling joist or
wall stud. The Fan Body
1
should be level and
perpendicular to the joist or stud.
❶
Joist or
wall stud
3
4. Mount the Fan Body
1
to the joist or stud using
nails or wood screws(not included) were indicated.
Joist or wall stud
1
1
4
5. Remove the fan junction box cover. Using wire
nut(not supplied), connect house wires to fan wires
as shown in the wiring diagram on page 1. 14AWG
is the smallest conductor that shall be used for
branch circuit wiring. Reattach fan junction box
cover.
wire nut
(not included)
Product
wires
House
wires
5
6. Install a circular 3 in. duct (not included) and secure
it with duct tape or clamps (neither included).
Finish ceiling work. The ceiling hole should be
aligned with the edge of the fan housing.
Ceiling
3 in. Duct
Duct tape
or clamp
6
EXISTING CONSTRUCTION
BEFORE INSTALLATION
Turn off power source. Review all safety precautions.
1. Remove existing fan.
1
2. Measure the opening to ensure it is large enough to
accommodate the new Fan Body (7 1/2 in. x 7 1/4
in.).
Note: 7 1/4 inch side of opening should be flush with
the joist.
2
3. If this fan is not replacing an old fan, be sure to cut
a 7 1/2 in. x 7 1/4 in. opening for the Fan Body
1
.
Make sure the 7 1/4 inch side of opening is flush
with the joist for installation from below.
a
A
9.4"
9.4"
7
1/2
in.
7
1/4
in.
3
4. Attach the Duct Connector
3
to the Fan body.
Remove the wiring box cover from the Fan Body
1
.
Remove the wiring knockout from the wiring box
cover with a flathead screwdriver (not included).
Remove the three screws that hold the fan motor
assembly in place. Remove the fan motor assembly
from the Fan Body
1
. Unplug fan connector.
❶
4
