2
PACKAGE CONTENTS
PART DESCRIPTION
APPEARANCE
QTY
1
Fan Body
1
2
Grille
1
3
Duct Connector
1
WIRING DIAGRAM
Turn off power source. Review all safety precautions.
FAN SWITCH
LIGHT SWITCH
OFF
ON
OFF
ON
GRD
L
N
L
N
WHITE
BLACK
RED
GREEN
WHITE
ON/OFF SWITCH
(purchase separately)
SWITCH BOX
120 VAC
LINE IN
FAN
SWITCH
WIRING
PLATE
LIGHT
SWITCH
BLACK
WHITE
GROUND
RED
SWITCH BOX
JUNCTION BOX
WIRE NUT
(NOT INCLUDED)
WIRE NUT
(NOT
INCLUDED)
FAN SWITCH
LIGHT SWITCH
OFF
ON
OFF
ON
GRD
L
N
L
N
WHITE
BLACK
RED
GREEN
WHITE
ON/OFF SWITCH
(purchase separately)
SWITCH BOX
120 VAC
LINE IN
FAN
SWITCH
WIRING
PLATE
LIGHT
SWITCH
BLACK
WHITE
GROUND
RED
SWITCH BOX
JUNCTION BOX
WIRE NUT
(NOT INCLUDED)
WIRE NUT
(NOT
INCLUDED)
ASSEMBLY INSTRUCTIONS
NEW CONSTRUCTION
Turn off power source. Review all safety precautions.
1. Attach the Duct Connector
3
to the Fan Body
1
3
1
1
2. Remove the wiring box cover from the Fan Body
1
.
Remove the wiring knockout from the wiring box
cover with a flathead screwdriver (not included).
1
2
3. Place the Fan Body
1
next to a ceiling joist
or wall stud. The fan body should be level and
perpendicular to the joist or stud.
1
3
4. Mount the Fan Body
1
to the joist or stud using
nails (not included) where indicated.
Joist or
wall stud
1
4
5. Pull the wire through the hole and into the junction
box(not included), secure 120VAC house wiring from
the wall diagram on page4. 14AWG is the smallest
conductor that shall be used for branchcircuit wiring.
Push the wires back through the hole. Reattach the
wiring box cover.
5
6. Install a circular 4 in. duct (not included) and secure
it with duct tape or clamps (neither included).
Finish ceiling work. The ceiling hole should be
aligned with the edge of the Fan Body
1
.
Ceiling
4 in. Duct
Duct tape
or clamp
1
6
EXISTING CONSTRUCTION
Turn off power source. Review all safety precautions.
1. Remove existing fan.
1
2. Measure the opening to ensure it is large enough to
accommodate the new Fan Body(7 1/2in. x 7 1/4in).
Note: 7 1/4 inch side of opening should be flush with
the joist.
2
3. If this fan is not replacing an old fan, be sure to cut
a 7 1/2in. x 7 1/4in. opening for the Fan Body
1
.
Make sure the 7 1/4 inch side of opening is flush
with the joist for installation from below.
7 1/2 in.
7 1/4 in.
3
4. Attach the Duct Connector
3
to the Fan Body
1
.
3
1
4
