Delta BIESEMEYER 78-939, Руководство пользователя

Страница: 2 / 8

ASSEMBLY
DISCONNECT SAW FROM POWER SOURCE UNTIL
ALL ASSEMBLY AND SET-UP PROCEDURES HAVE
BEEN COMPLETED.
FOR BIESEMEYER ® COMMERCIAL OR HOME SHOP
FENCES ONLY.
1. Fold template (A) Fig. 2, on fold line and align the
template with the bottom of fence board (B). Using a punch,
mark the fence board (B) as indicated on the template (A)
for Commercial or Home Shop installation. Then proceed
to section
“FOR ALL FENCES” STEP 8.
FOR BRANDS OTHER THAN BIESEMEYER
2. Place cut-off support (C) Fig. 3, onto saw fence (D) as
shown.
3. Place a straight edge (E) Fig. 3, approximately
1/16”- 1/8” thick, onto saw table as shown. Then, place
cut-off fence board (F) Figs. 3 and 4, vertically onto straight
edge (E) and against saw fence (D) with the unfinished
edge down as shown in fig. 4.
4. Hold cut-off fence board (F) Fig. 4, Firmly against
cut-off fence support (C), and draw a line across the rear
of cut-off fence board (F) as shown.
5. Remove cut-off fence board (F) Fig. 4, and cut-off fence
support (C) from saw fence (D), and place cut-off fence
board onto a flat, supporting surface with pencil marks
facing up as shown in Fig. 5.
6. Align the top of cut-off fence support (C) Fig. 5, with the
pencil line on cut-off fence board (F) and center cut-off
fence support (C) onto board.
7. Using a pencil, mark the back of cut-off fence board (F)
Fig. 5, through the two holes (G) in cut-off fence support
(C).
Fig. 2
Fig. 3
Fig. 4
Fig. 5
2
A
B
D
C
E
F
D
C
E
F
C
F G