BS PLUG WIRING
Should it be necessary to change the plug please note the wires in
the mains lead are coloured in accordance with the following code:
BLUE - NEUTRAL
BROWN - LIVE
GREEN AND YELLOW - EARTH
As the colours of the wires in the mains lead of this appliance may
not correspond with the coloured markings identifying the terminals
in your plug, proceed as follows:
1. The BLUE wire is the NEUTRAL and must be connected to
the terminal that is marked with the letter N or coloured
BLACK.
2. The BROWN wire is the LIVE and must be connected to the
terminal that is marked with the letter L or coloured RED.
3. The GREEN/YELLOW is the EARTH and must be connected
to the terminal which is marked with the letter E or or
coloured GREEN OR GREEN /YELLOW.
4. Always ensure that the cord grip is positioned and fastened
correctly.
If a 13A (BS 1363) fused plug is used it must be fitted with a 13A
fuse. If in doubt consult a qualified electrician.
Wiring for a 13 Amp Plug (BS1363)
Please note: The Earth Terminal is marked with the letter E or
Earth Symbol.
-3-
FOR ROOM HUMIDIFICATION
•
Turn the product OFF at the MAINS SWITCH and remove the
plug from the mains socket.
•
Open the top cover and pour clean water into tank. The water
level indicator on the front of the Evaporative Cooler shows
the level of water in the tank. Then connect to the power
supply and turn on the MAINS SWITCH.
•
Press the POWER button and the fan will start at medium
speed, after few seconds, it will switch to LOW speed.
•
To turn the product OFF press the POWER button again. The
fan will continue to run for approximately 3 minutes to extend
the life of the working parts. If you do not intend to use the
product for some time also turn off the MAINS SWITCH.
•
Press the MODE button twice to select the WARM MODE,
indicated by the LED.
•
The Heater will start in LOW mode, indicated by the LED
under L on the control panel.
•
Press the SPEED button to increase or decrease fan speed.
•
Press the HEATING button twice to select the HUMIDIFIER
mode, indicated by the HUM LED with
HIGH heat.
•
Press HEATING button again for humidifier and LOW heat.
•
Press the HEATING button to return to the LOW heat mode
without humidifier.
•
When the water in the tank has been used refill as above.
•
To empty the water tank turn your product off at the POWER
button and MAINS SWITCH. Carefully pull the tank from the
main body and dispose of the water. Refit the tank correctly
or your evaporative cooler will not work correctly. See Tank
Fitting instructions. Alternatively use the drain at the rear of
the tank.
-8-
