5
3.2 Selection of the Installation Location
3.2.1 Selecting Installation Site
Select an installation site where the following conditions are fulfilled and that meets your
customer's approval .
(1) Obstruct should put away from the intake or outlet vent of the indoor unit so that the airflow
can be blown though all the room.
(2)
Make sure that the installation had accord with the requirement of the schematic diagram of
installation spaces.
(3)
Select the place where can stand 4 times of the weight of the indoor unit and would not
increase the operating noise and oscillate.
(4)
The horizontally of the installation place should be guaranteed.
(5)
Select the place where easy drain condensated coagulated water, and easy connect with
outdoor unit.
(6)
Make sure that there are enough space for care and maintenance. Make sure that the
weight between the indoor unit and ground is above 1800mm.
(7)
When installing the steeve bolt, check if the install place can stand the weight 4 times of
the unit’s. If not, reinforce before installation. (Refer to the install cardboard and find where
should be reinforced)
3.2.2. Installation Space Requirements
The space around the unit is adequate for ventilation Unit:mm
H
Ground
surface
Wall
surface
Wall
surface
Wall
surface
>20
unit:mm
Model
H
230
80CM008J24
80CM010J24
Fig.1
