10
Fig. 23
Fig. 24
Fig. 25
Fig. 26
3.
Assemble six-position filter bag hanger assembly
(G) Fig. 23, to the top half of the upper bag support (H).
Place a 5/16" lockwasher (I) onto a 5/16-18x1¼" hex
head screw (J), place a special washer (K) (30mm O.D.,
8mm I.D., 3mm thick), onto the screw, insert the screw
through the filter bag hanger and place special washer
(L) (30mm O.D., 8mm I.D., 3mm thick) onto screw.
Thread the screw into the top half of upper bag support.
Assemble the remaining six-position hanger to the other
upper bag support (H) in the same manner.
4.
Insert the upper bag support (H) Fig. 24, into the
lower bag support (H), making certain the pin (F) in lower
bag support engages hole in upper bag support.
Assemble the remaining bag support in the same
manner.
5.
Position top of filter bags (J) Fig. 24, onto both hanger
assemblies (G) as shown, until all twelve filter bags are
positioned (6 each) on both hanger assemblies.
6.
IMPORTANT:
Each filter bag (J) Fig. 25, features a
channel (K) in the hem of the bag. This will allow the
filter bag (J) to be positioned and held inside the lip of
six holes in each drum assembly (B). Insert the open end
of each bag (J) Fig. 26, into the hole in the drum
assembly until the channel (K) in the bag is positioned
over the lip of each drum opening as shown. Assemble
the remaining 11 filter bags to the two drums in the
same manner.
G
H
J
H
G
J
G
J
G
J
H
F
A
J
K
B
J
K
B
K
I
L
