Delta 37-380, Инструкция по эксплуатации

Страница: 13 / 28

13
ASSEMBLING SWITCH AND
MOUNTING BRACKET
1. Align the two holes in the switch mounting bracket
(A) Fig 22, with the two holes (D) in the back of the infeed
table (B). Place an M8.1 lockwasher (E) Fig. 22, then an
M8 flat washer (F), on an M8x1.25x16mm hex socket
head screw (C). Insert the screw through the hole (D) Fig.
22, in the switch mounting bracket (A) and thread the
screw into the tapped hole in the back of the infeed table
(B), and tighten securely. Repeat this process for the
remaining hole in the switch mounting bracket and the
infeed table.
2. Align the hole (E) Fig. 23 in the switch, with the hole
(G) in the mounting bracket. Place an 11/32" flat washer
(I) Fig. 23, on a 5/16-18x1" hex head screw (H). Insert the
screw through the hole in switch (E) and hole (G) in the
mounting bracket. Place a 5/16" lockwasher (J) on
screw (H). Thread a 5/16-18 hex nut (K) on the screw
and tighten securely.
3. Fig. 24, illustrates the switch properly mounted.
Fig. 22
Fig. 23
Fig. 24
A
D
D
B
E
F
C
E
G
I
H
J
K
Fig. 25 Fig. 26
ASSEMBLING DUST CHUTE
The jointer stand has a built-in dust chute (A) Fig. 25. If
this machine is to be used with a dust collection system,
the supplied dust collector connector (B) Fig. 26, can be
fastened to jointer stand (C) with four #10-16x1/2" sheet
metal screws (D) as shown.
A standard 4" dust collection hose can be attached to
dust collector connector.
A
D
B
C