15
Fig. 39
Fig. 38
Fig. 37
Fig. 36
USING TABLE ASSEMBLY
WITH SANDING BELT
When the sanding arm (A) Fig. 36, is used in the vertical
position, the complete table assembly (B) can be moved
from the disc unit to the belt unit as follows:
1.
Remove the backstop (C) Fig. 36.
2.
Locate and thread the 13/16" (20mm) long socket
head screw (D) Fig. 36, into base casting as shown.
NOTE:
Only thread screw (D) partway into base casting.
3.
Loosen screw (E) Fig. 36, and remove support bar
(F) and table assembly (B) from disc unit. Insert bar (F)
into hole (G) on belt unit and tighten screw (D).
4.
Fig. 37, illustrates the table assembly (B) assembled
to the belt unit.
WARNING: THE TABLE EDGE (G) MUST BE
POSITIONED A MAXIMUM OF 1/16 INCH AWAY
FROM THE SANDING BELT (H) TO AVOID TRAPPING
THE WORK OR FINGERS BETWEEN THE TABLE AND
SANDING BELT
.
DUST SPOUT
A dust spout (A) Fig. 38, is supplied with your sander and
can easily be connected to a standard shop vacuum
hose. The outside diameter of the opening of the dust
spout is 2-1/2 inches.
WRENCH STORAGE
Two holes are provided in the base casting and are used
for storing the two wrenches (A) Fig. 39, supplied with
the sander.
A
C
D
G
E
F
B
H
G
B
A
A
