21
D
A
TIGHTEN
LOOSEN
F
ADJUSTMENTS
E
DEPTH STOP ADJUSTMENT
FENCE EXTENSION
ALIGN BLADE TO FENCE CONT’D
This miter saw is equipped with an adjustable depth stop for
making through cuts and non-through cuts.
Refer to Figure 32 and follow these instructions in
order to set the depth stop at a specific cut depth:
rotate the stop bracket (C) counterclockwise into the down
position. The cut depth can now be adjusted by turning the
depth adjustment screw (D).
Refer to figure 32 and follow these instructions in
order to make a through cut: rotate the stop bracket (C)
clockwise into the up position.
This saw is equipped with an adjustable extension fence.
To extend or retract the fence refer to Figure 33 and follow
these instructions: Loosen the lock knob (E) by rotating
counterclockwise and the slide the fence (F) into the desired
position. Make sure to re-righten lock knob (E) by rotating
clockwise.
Always check to make sure lock knob (E) is
tightened before making a cut. Failure to do so may result in
injury.
Figure 32
Figure 31
Figure 33
NOTE:
Make sure the square contacts the flat part of the
blade and not the teeth.
6.
If the blade face is not flush with the square you will
need to adjust the miter detent plate
See Figure 31
7.
Loosen the four screws (A) and move the miter table to
adjust the miter detent plate position. Set so the fence
and blade are flush against the combination square.
Make sure the miter lock knob is not locked, so the
miter detent plate may be adjusted.
8.
Re-tighten the four screws and re-check the blade-to-
fence alignment.
NOTE:
This saw has two scale indicators, one on the bevel
scale and one on the miter scale. After squaring adjustment
have been made, it may be necessary to loosen the indicator
screws (B) and reset them to zero.
B
C