Delta 23-710, Инструкция по эксплуатации

Страница: 9 / 24

9
ASSEMBLING AND
ADJUSTING TOOL REST
FOR DRY WHEEL
1. Assemble dry wheel tool rest (A) Fig. 7, to mounting
arm (B) using flat washer (C), lockwasher (D) and
5/8” long hex head screw (E). Place a lockwasher
then a flat washer on the hex head screw, then
assemble tool rest to mounting arm as shown in Fig.
8.
WRENCH HOLDING BRACKET
1. Wrench (D) Fig. 10, can be stored in bracket (A)
when not in use.
2. Figure 8, illustrates dry wheel tool rest (A) assembled
to mounting arm (B). Wrench (F) supplied, is used to
tighten screw (E).
3. The tool rest (A) Fig. 8, is adjustable so the inside
edge of the tool rest can be positioned as close to
the grinding wheel (H) as possible, giving maximum
support to the piece that is being ground. Always
maintain a distance of 1/8” or less between the
grinding wheel (H) and inside edge of tool rest (A). As
the grinding wheel wears down to a smaller
diameter, readjust the tool rest closer to the wheel by
loosening screw (E), moving tool rest (A) inward and
tightening screw (E) using wrench (F). The tool rest
(A) can also be rotated to any desired angle by
loosening screw (E), rotating tool rest (A) and
tightening screw. Rotate dry wheel (H) making
certain wheel does not contact tool rest (A).
A
D
A
C
D
E
F
Fig. 7
Fig. 8
Fig. 10
B
H
B
E
A