11
Fig. 22
Fig. 23
Fig. 24
Fig. 25
Fig. 22 illustrates the cut-off piece after the cut is com-
pleted.
NOTE:
The number of cuts per wheel, as well as
the quality of cut, may vary considerably with the cutting
time. Fast cuts cause the wheel to wear more rapidly,
but also help to reduce discoloration and burr.
3.
Press in on arbor lock (B) Fig. 24, and at the same
time rotate wheel (F) by hand until the arbor lock engages.
4.
Using the wrench provided, loosen arbor screw (C)
Fig. 25, by turning it counterclockwise, and remove
arbor screw (C), washer (D), outside wheel flange (E) and
wheel (F).
DO NOT REMOVE INSIDE WHEEL FLANGE
.
5.
Make sure the inside surfaces of both the inside and
outside wheel flanges are clean and free from any foreign
substance.
6.
Install new wheel (F) Fig. 25, outside wheel flange
(E), washer (D) and arbor screw (C). Turn arbor screw (C)
clockwise to tighten.
IMPORTANT: USE ONLY
RECOMMENDED REINFORCED ABRASIVE WHEELS
WITH BLOTTERS AND TIGHTEN THE ARBOR SCREW
(C) ONLY ENOUGH TO HOLD THE WHEEL FIRMLY AND
PREVENT WHEEL SLIPPAGE. EXCESSIVE TIGHTEN-
ING MAY RESULT IN DAMAGE TO THE WHEEL AND
SPRINGING THE WHEEL FLANGES.
7.
Rotate front wheel guard to the down position and
make sure spindle lock is disengaged before turning the
machine on.
MAINTENANCE
CHANGING THE WHEEL
1.
DISCONNECT THE MACHINE FROM THE POWER
SOURCE.
2.
Rotate the front wheel guard (A) Fig. 23, to the up
position, as shown.
A
F
B
F
C
D
E