Delta 11-990C, Инструкция по эксплуатации

Страница: 4 / 16

4
UNPACKING AND CLEANING
Your drill press is shipped complete in one container. Carefully unpack the drill press and all loose items from the
container. Figure 2 illustrates the drill press and all loose items supplied with the machine. After assembly remove the
protective coating from the table surface. This coating may be removed with a soft cloth moistened with kerosene (do
not use acetone, gasoline or lacquer thinner for this purpose). After cleaning, it is good practice to cover the table
surface with a good quality paste wax. Buff out the wax thoroughly to prevent it from rubbing into your workpiece.
WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE TOOL TO THE POWER SOURCE UNTIL THE
MACHINE IS COMPLETELY ASSEMBLED AND YOU HAVE READ AND UNDERSTOOD THE ENTIRE
INSTRUCTION MANUAL.
1 - Drill Press Head and Motor
2 - Column, Base Flange and Table Raising
Mechanism
3 - Clamp Handle
4 - Table
5 - Base
6 - Pinon Shaft Handles (3)
7 - Chuck
8 - Chuck Key
9 - Wrenches (2)
10 - Worm Gear for Table Raising and Lowering
Mechanism
11 - Table Raising and Lowering Handle
12 - 25mm (1") long Hex Head Cap Screws (4)
13 - 125mm (5") long Carriage Screws (2), Flat Washers
(2), Lock Washers (2), Hex Nuts (2)
Fig. 2
1
2
3
4
5
6
7
8
9
10
12
11
13