Delta Tau ACC-F1, Руководство пользователя

Страница: 8 / 12

Accessory F1
SETUP OF ACC-F1
The ACC-F1 UMAC power supply comes from the factory configured to operate in the UMAC rack.
The 5Vdc remote voltage sense is configured to operate in the factory default configuration.
This power supply should only need to be plugged in at the power supply connector of the UMAC back
plane.
WARNING
24dc Input power must not be supplied while plugging the power supply accessory
card into the back plane! Damage may occur if the power supply is hot-plugged
into a load!
POWER LED DISPLAY
There are 3 LEDs on the front panel to indicate that the power supply is operating correctly.
Refer to the cutout photo below for the positioning of the LEDs on the front panel:
2 Introduction & Setup