ESB6-RA30/45/60 Right-Angle Nutrunner
Operation Manual
www.deltaregis.com
Page 5
Indicators
Rundown Status Indicator [1]
When the driver reaches the set torque and clutches out it will emit a short beep and
the green rundown LED will flash once indicating an OK rundown. If the driver does not
clutch out before the operator releases the trigger the driver will emit a long beep and
the red rundown LED will flash once indicating a NG rundown.
Battery Status Indicator [2]
The ESB6 Series Cordless Screwdrivers are programmed to avoid poor performance if
the battery charge gets too low. When the available battery power reaches 20%, the
tool will continue to function and the red battery LED will flash accompanied by several
short beeps. When the battery reaches 10% charge, the red battery LED will illuminate
for a few seconds accompanied by several beeps. The driver will stop functioning. At
this point remove and replace the discharged battery with a fully charged battery to
continue production.
[1]
[2]
Quick Set-Up and Operation Overview
1. Fully charge the battery using the battery charger before first use to achieve
maximum fastening cycles.
2. Ensure that the screwdriver’s FWD/REV switch is ‘OFF’ (central position).
3. Install a power socket onto the tool’s square drive.
4. Switch the FWD/REV switch to the appropriate direction. Select the desired speed
(Hi/Lo) via the switch on the top of the screwdriver.
5. Securely grip the screwdriver so that the index finger on the dominant hand is
comfortably over the trigger mechanism, and the non-dominant hand is supporting
the front of the tool.
6. Align the socket properly over the head of the fastener. Keeping the driver in-line
with the fastener, pull and hold the start trigger — the screwdriver will install the
fastener (FWD). When the preset torque is reached, the clutch will activate and the
tool will shut-off. Once the tool shuts off, release the trigger to reset. To stop the
screwdriver before the fastening is complete, release the start trigger.
7. To remove a fastener, change the FWD/REV switch to the REV position. Pull the start
trigger to run the driver in reverse (CCW). Do not change the position of the FWD/
REV switch while the tool is running.
