Delta OHM HD2301.0, Руководство по эксплуатации, Страница: 17 / 28

HD2301
- 17 -
V1.7
INSTRUMENT SIGNALS AND FAULTS
The following table lists all error indications and information displayed by the
instrument and supplied to the user in different operating situations:
Indicazione a display Spiegazione
- - -
This appears in the display central line when a temperature only
probe is connected. In the lower line the temperature is shown
correctly.
PRBE_TYPE Type of probe connected.
BATT TOO LOW
CHNG NOW
Indication of insufficient battery charge appearing on turning
on. The instrument issues a long beep and turns off. Replace
the batteries.
CAL
LOST
Program error: it appears after turning on for a few seconds.
Contact the instrument's supplier.
CAL__11_ UP DOWN
Calibration at 11% RH, use the arrows to correct the value
proposed.
CAL__33_ UP DOWN
Calibration at 33% RH, use the arrows to correct the value
proposed.
CAL__75_ UP DOWN
Calibration at 75% RH, use the arrows to correct the value
proposed.
ERR
This appears if the probe has already been detected by the
instrument, but is disconnected. At the same time an
intermittent beep is issued.
FUNC CLRD Max, min and average values cleared
NEW PROBE DET
This message appears when a probe is inserted into a
functioning instrument. Turn the instrument off and then back
on again.
NO_PRBE_ SER_NUM The connected probe's serial number is absent.
nonE No selection.
OVER
Measurement overflow: indicates that the probe is measuring a
value exceeding the measuring range.
PLS_EXIT >>> FUNC
RES_FOR_FACT ONLY
Please exit using ESC >>> function reserved to factory
calibration.
PRBE_SER #### #### Serial number #### #### of the connected probe.
PROB
ERR
A probe with SICRAM module has been inserted when not
admissible for that specific instrument.
PROB COMM LOST
This appears if the probe has already been detected by the
instrument, but is disconnected. At the same time an
intermittent beep is issued.
PROB_CAL_EXIT_OR_7
5_OR_33_OR_11
Probe calibration - exit or select 75, 33 or 11% RH.
SYS
ERR
#
Instrument management program error. Contact the instrument's
supplier and communicate the numeric code # reported by the
display.