Delta Electronics DVP15MC11T, Руководство по эксплуатации

Страница: 442 / 601

Chapter 12 Troubleshooting
11
11.3.21 DMC_TouchProbe
FB/FC Explanation Applicable model
FB DMC_TouchProbe is used for capturing the position of an axis. DVP15MC11T
DMC_TouchProbe
Ax is Done
DMC_Touc hProbe_in stanc e
Ex ecut e
Trigg erI nput
Busy
Ac tiv e
Windowonly
Error
ErrorID
CommandAborted
Firs tpos
Las tpos
Mode
Mas k
Rec ordedPosition

Input Parameters
Parameter
name
Function Data type
Valid range
(Default)
Validation
timing
Axis
Specify the number of the axis which is to
be controlled.
USINT
1~32
(The variable value
must be set)
When
Execute
changes
from
FALSE to
TRUE
Execute
The instruction is executed when
Execute changes from FALSE to TRUE.
BOOL
TRUE or FALSE
(FALSE)
-
TriggerInput
Specify one of the input points I0~I7,
I10~I17 of DVP15MC11T as the bit for
triggering position capture. The values of
the parameter 0~15 correspond to input
points I0~I7 and I10~I17.
The parameter is valid when
Mode is 0
and 1 and invalid when Mode is 2, 3 and
4.
MC_Triggerinput
0:mcTriggerinputI0
...
7: mcTriggerinputI7
8:mcTriggerinputI10
...
15:
mcTriggerinputI17
(0)
Windowonly Reserved - - -
Firstops Reserved - - -
Lastops Reserved - - -
Mode
Mode 0: The trigger signal comes from
the rising edge of the input
points: I0~I7 and I10~I17 of
DVP15MC11T. The input point
which is used is specified by
TriggerInput . The position is
captured through the rising edge
of the trigger bit. The captured
position is converted from the
number of pulses that the
external encoder port of the
controller receives through axis
parameters. INT
11-119