Delta Electronics AE57BSTD, Быстрый старт

Страница: 3 / 37

English-2
Maintenance and Inspection
¾
Do not touch any internal or exposed parts of the HMI as electrical shock may result.
¾
Do not remove operation panel while power is on. Otherwise electrical shock may result.
¾
Wait at least 10 minutes after power has been removed before touching any HMI terminals or
performing any wiring and/or inspection as an electrical charge may still remain in the HMI with
hazardous voltages even after power has been removed.
¾
Turn the power off before changing backup battery and check system settings after finishing change.
(all data will be cleared after changing battery).
¾
Be sure the ventilation holes are not obstructed during operation. Otherwise malfunction may result
due to bad ventilation or overheating troubles.
Wiring Method
¾
Remove the terminal block from the HMI before wiring.
¾
Insert only one wire into one terminal on the terminal block.
¾
If the wiring is in error, perform the wiring again with proper tools. Never use force to remove the
terminals or wires. Otherwise, it may result in malfunction or damage.
¾
For the power line that forced to take out, ensure to check wiring again and restart.
Communication Wiring
¾
Comply with communication wiring specification for wiring.
¾
Wiring length should comply with the stated specification for the HMI.
¾
Proper grounding to avoid bad communication quality.
Installation and Storage Conditions
The product should be kept in the shipping carton before installation. In order to retain the warranty coverage,
the HMI should be stored properly when it is not to be used for an extended period of time. Some storage
suggestions are:
„ Store in a clean and dry location free from direct sunlight.
„ Store within an ambient temperature range of -20
°
C to +60
°
C (-4
°
F to 140
°
F).
„ Store within a relative humidity range of 10% to 90% and non-condensing.
„ Do not store the HMI in a place subjected to corrosive gases and liquids.
„ Correctly packaged and placed on a solid and durable surface.
„ Do not mount the HMI adjacent to heat-radiating elements or in direct sunlight.
„ Do not mount the HMI in a location subjected to corrosive gases, liquids, or airborne dust or metallic
particles.
„ Do not mount the HMI in a location where temperatures and humidity will exceed specification.
„
Do not mount the HMI in a location where vibration and shock will exceed specification.
„ Do not mount the HMI in a location where it will be subjected to high levels of electromagnetic
radiation.
Installation
Installation Note:
„
Improper installation will result in malfunction and greatly reduce the life of the HMI. Be sure to
follow the guidelines in this quick start when installing the HMI.
„ In order to ensure the HMI being well ventilated, make sure that the ventilation holes are not
obstructed and must provide sufficient free space around HMI.
„ For use on a flat surface of a Type 4X "Indoor Use Only" enclosure or equivalent.