7
COMPLETING THE INSTALLATION
Note: Remove the eight rubber packing mounts
from the fan motor assembly and discard prior
to attaching the blade arms.
4.
Blade installation (Fig. 13), attach the fan blades
to the blade holders by using three blade screws.
Tighten screws securely. Repeat this step for the
remaining blades.
Note: Make sure the side with a mark
“This side up” is installed upward.
5.
Loosen 2 of the preassembled screws and remove
1 from the plate on the motor. Save this screw
for later use. Align the keyhole slots on the light
kit plate with the preassembled screws on the
motor plate. Twist clockwise untill it locks. Reinstall
the screw that was removed. Tighten all screws
securely. (Fig.14)
6.
Remove the three LED module screws on the light
kit plate. Save screw for later use. Connect brown
wire from fan to brown wire from LED module
and then connect blue wire from fan to blue wire
from LED module. Align the hole slots on the light
kit plate with the hole slots on the LED module.
Reinstall the screw that was removed. Tighten all
screws securely. (Fig.15)
WARNING: Shut off the power supply before
removing or replacing light kit.
7. Raise the glass shade up against light kit and make
sure to align the notches on the glass with the
notches on the light kit plate. Secure it to the fan
by turning clockwise until snug. (Fig.16)
WARNING: Do not overtighten.
NOTE:
Total wattage consumed by the light kit is 20W and
this fan is equipped with a wattage limiting device.
A certain amount of wobble may be considered
normal, especially if the fan is on a down-rod long
than 12".
THIS SIDE U
P
Blade
Screws
Light kit plate
LED module
Glass shade
Notch
Notch to secure glass
15
16
13
14
