Digital Projection
E-Vision Laser 13000 WU
Rev A January 2019
Page 16
Important Information
Connecting the power supply
Adjust the
VOLTAGE SELECT switch
1
to the required voltage, then firmly push the mains
connector into the
socket
2
.
Voltage selection
The VOLTAGE SELECT switch must be set to match the power supply you are using:
Voltage of power supply used
Position of VOLTAGE SELECT switch
100-130VAC outlet
200-240VAC (single phase) outlet
Use only the power cable provided.
Ensure that the power outlet includes a ground connection as this equipment MUST be
earthed.
Handle the power cable carefully and avoid sharp bends. Do not use a damaged power
cable.
1
2
